1.INSTALL CONDENSER ASSEMBLY
Attach the 2 guides to install the condenser assembly as shown in the illustration.
Do not damage the condenser or radiator when installing the condenser assembly.
If a new condenser assembly is installed, add compressor oil to the condenser as follows.
Add 40 cc (1.35 fl. oz.)
ND-OIL 8 or equivalent
16712
2.INSTALL NO. 2 FAN SHROUD
Install the No. 2 fan shroud with the 2 bolts.
Attach the 3 clamps to connect the water by-pass pipe to the No. 2 fan shroud.
16533B
3.INSTALL NO. 1 RADIATOR SUPPORT
88706
4.CONNECT LIQUID PIPE SUB-ASSEMBLY
Remove the vinyl tape from the liquid pipe sub-assembly and the connecting part of the condenser with receiver assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.
ND-OIL 8 or equivalent
Install the O-ring to the liquid pipe sub-assembly.
Connect the liquid pipe sub-assembly to the condenser assembly with the bolt.
88703
5.CONNECT DISCHARGE HOSE SUB-ASSEMBLY
Remove the vinyl tape from the discharge hose sub-assembly and the connecting part of the condenser with receiver assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.
ND-OIL 8 or equivalent
Install the O-ring to the discharge hose sub-assembly.
Connect the discharge hose sub-assembly to the condenser with receiver assembly with the bolt.
16681
6.INSTALL RADIATOR UPPER AIR GUIDE PLATE
52029
7.INSTALL FRONT BUMPER UPPER REINFORCEMENT SUB-ASSEMBLY
8.INSTALL HEADLIGHT
for Halogen Headlight: Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for Halogen Headlight)>INSTALLATION
for HID Headlight: Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY(for HID Headlight)>INSTALLATION
53301
9.ADJUST HOOD SUB-ASSEMBLY
10.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
11.WARM UP ENGINE
12.INSPECT FOR REFRIGERANT LEAK