Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
1.INSTALL HEADLIGHT ASSEMBLY LH
| *1 | Protective Tape |
| *2 | Bolt |
| *3 | Screw |
Put protective tape around the headlight assembly LH.
Connect each connector.
Install the headlight assembly LH with the bolt and 3 screws.
52119A
2.INSTALL FRONT BUMPER COVER
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.ADJUST HEADLIGHT AIMING
5.ADJUST FOG LIGHT AIMING