Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Front Door) › 2012.12–2015.10
RM3090E _59 Vehicle Exterior _008792 WINDOW / GLASS _0050078 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 85720C 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

a.

Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly LH.


b.
E268550

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly LH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new window regulator motor uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 69802 2.INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

Hide 68102 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 67832 4.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 67602 5.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74642A 6.INSTALL FRONT DOOR ASSIST GRIP COVER LH

Hide 69284C 7.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 8.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)

Hide 9.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)

Hide 67492A 10.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12.INITIALIZE POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function)