Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH
RM3090E _59 Vehicle Exterior _008795 WIPER / WASHER _0050087 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.


·

The procedure listed below is for LHD vehicles.


·

Use the same procedure for the RH and LH sides.


·

The procedure listed below is for the RH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45186 4.REMOVE LOWER NO. 2 STEERING WHEEL COVER

Hide 45100 6.REMOVE STEERING WHEEL ASSEMBLY

Hide 45286 7.REMOVE STEERING COLUMN COVER

Hide 84650 8.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

a.
E268398C01
2,0.969 2,0.354 true 1.927,0.188 2.24,0.385 0.313,0.198 10 *1
*1 Protective Tape


Disconnect the 2 connectors.


b.

Using a screwdriver, detach the claw and remove the windshield wiper switch assembly.

NOTICE:

Do not push the claw with excessive force as damage may occur.


HINT:

Tape the screwdriver tip before use.