Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
4.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL
74642A
5.REMOVE FRONT DOOR ASSIST GRIP COVER LH
69284C
6.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
67602
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
87940
8.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
67832
9.REMOVE FRONT DOOR SERVICE HOLE COVER LH
68102
10.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
68151D
11.REMOVE FRONT DOOR GLASS RUN LH
75720
12.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH
67862
13.REMOVE FRONT DOOR WEATHERSTRIP LH
75792
14.REMOVE DOOR WINDOW FRAME MOULDING CLIP
75756C
15.REMOVE FRONT DOOR WINDOW REAR FRAME MOULDING LH
75922M
16.REMOVE NO. 1 BLACK OUT TAPE LH
When removing the No. 1 black out tape, heat the frontdoor panel and No. 1 black out tape using a heat light.
| Item | Temperature |
|---|---|
| Front Door Panel | 40 to 60°C (104 to 140°F) |
| No. 1 Black Out Tape | 20 to 30°C (68 to 86°F) |
Do not heat the front door panel or No. 1 black out tape excessively.
Pull back an edge of the No. 1 black out tape and pull it parallel to the front door panel to remove it.