Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
89960
1.INSTALL HEADLIGHT LEVELING ECU ASSEMBLY
Install the headlight leveling ECU assembly with the bolt.
Connect the connector.
55312
2.INSTALL LOWER INSTRUMENT PANEL
55302A
3.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
5.CHECK SRS WARNING LIGHT
6.INITIALIZE HEIGHT CONTROL SENSOR SIGNAL