Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION).
87940
1.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
Attach the claw and 2 clips.
Temporarily install the outer rear view mirror assembly LH to the front door panel with the 3 screws.
When reusing the outer rear view mirror assembly LH, be sure to temporarily install the screws by hand so that the threads of the mirror are threaded correctly.
Tighten the 3 screws.
As the threads of the mirror may become stripped, causing the mirror to fall off, do not tighten the screws with more than the specified torque.
When retightening the screws, do not retighten a screw more than 2 times. However, if the screw is being installed in the same location it was removed from, it is acceptable to retighten it 3 times.
Connect the connector.
67602
2.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
69284C
3.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
74642A
4.INSTALL FRONT DOOR ASSIST GRIP COVER LH
5.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
6.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67492A
7.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH