The fuel injectors are located on the intake manifold. They inject fuel into the cylinders based on the signals from the ECM.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| *a | Front view of wire harness connector
(to Fuel Injector Assembly) |
Disconnect the fuel injector assembly connectors.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B19-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B17-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B15-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B13-1 - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the fuel injector assembly (Click here Engine / Hybrid System>3ZR-FE FUEL>FUEL INJECTOR>INSPECTION).
Perform "Inspection After Repair" after replacing the fuel injector assembly (Click here Engine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the fuel injector assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B19-2 - B75-20 (#10) | Always | Below 1 Ω |
| B17-2 - B75-17 (#20) | Always | Below 1 Ω |
| B15-2 - B75-18 (#30) | Always | Below 1 Ω |
| B13-2 - B75-19 (#40) | Always | Below 1 Ω |
| B19-2 or B75-20 (#10) - Body ground | Always | 10 kΩ or higher |
| B17-2 or B75-17 (#20) - Body ground | Always | 10 kΩ or higher |
| B15-2 or B75-18 (#30) - Body ground | Always | 10 kΩ or higher |
| B13-2 or B75-19 (#40) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the fuel injector assembly connectors.
Remove the IG2 relay from the engine room relay block and junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B19-1 - 5 (IG2 relay) | Always | Below 1 Ω |
| B17-1 - 5 (IG2 relay) | Always | Below 1 Ω |
| B15-1 - 5 (IG2 relay) | Always | Below 1 Ω |
| B13-1 - 5 (IG2 relay) | Always | Below 1 Ω |
| B19-1 or 5 (IG2 relay) - Body ground | Always | 10 kΩ or higher |
| B17-1 or 5 (IG2 relay) - Body ground | Always | 10 kΩ or higher |
| B15-1 or 5 (IG2 relay) - Body ground | Always | 10 kΩ or higher |
| B13-1 or 5 (IG2 relay) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG