When the malfunction is not confirmed by the DTC check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when engine troubleshooting.
Conduct this check with the engine stopped and the ignition switch off.
| Result | Proceed to |
|---|---|
| 11 V or higher | OK |
| Below 11 V | NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the engine idling speed (Click here Engine / Hybrid System>3ZR-FE ENGINE MECHANICAL>ENGINE>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the fuel pressure (Click here Engine / Hybrid System>3ZR-FE FUEL>FUEL SYSTEM>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Perform a spark test (Click here Engine / Hybrid System>3ZR-FE ENGINE CONTROL>IGNITION SYSTEM>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG