16100
1.INSTALL ENGINE WATER PUMP ASSEMBLY
Remove the adhesive from the threads of the bolt and the bolt hole of the timing chain cover sub-assembly.
Install a new gasket to the timing chain cover sub-assembly so that the protrusions indicated by the arrows in the illustration are aligned.
Apply adhesive to 2 or 3 threads of the bolt labeled A.
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
| Item | Specified Condition |
|---|---|
| Bolt A and C | 45 mm (1.77 in.) |
| Bolt B | 30 mm (1.18 in.) |
Install the engine water pump assembly with the 2 bolts indicated by the arrows in the illustration.
Install the 5 bolts.
16604
2.INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY
Install the No. 2 idler pulley sub-assembly and No. 2 idler pulley cover plate with the bolt.
16603
3.INSTALL NO. 1 IDLER PULLEY SUB-ASSEMBLY
16649B
4.INSTALL IDLER PULLEY COVER PLATE
12341
5.INSTALL ENGINE MOUNTING SPACER
Install the engine mounting spacer with the 2 bolts.
12305
6.INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
Install the engine mounting insulator sub-assembly RH with the 5 bolts and nut.
Remove the jack.
Tighten the 4 bolts and 2 nuts to the front engine mounting insulator and rear engine mounting insulator.
Install the nut.
12156
7.INSTALL OIL PAN INSULATOR
16361A
8.INSTALL FAN AND GENERATOR V BELT
51217A
9.INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
16470
10.INSTALL RADIATOR RESERVOIR ASSEMBLY
11.ADD ENGINE COOLANT
12.INSPECT FOR COOLANT LEAK
12611
13.INSTALL NO. 1 ENGINE COVER
51443
14.INSTALL REAR ENGINE UNDER COVER RH
51441
15.INSTALL NO. 1 ENGINE UNDER COVER