Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050507 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67492A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 4.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

Hide 74642A 5.REMOVE FRONT DOOR ASSIST GRIP COVER LH

Hide 69284C 6.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

Hide 67602 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 89835 8.REMOVE DOOR SIDE AIRBAG SENSOR LH

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Disconnect the connector from the door side airbag sensor LH.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


i.

Push the housing lock and slide the outer housing. (At this time, the connector cannot be disconnected yet.)


ii.

Push the housing lock again and disconnect the connector.

NOTICE:

Do not push the connector housing part (A) when disconnecting the sensor connector.


C195226C13
1.083,1 0.906,0.563 true 3.604,1 3.427,0.563 true 4.094,1.76 3.917,1.323 true 1.552,1.76 1.375,1.323 true 0.917,1.156 0.583,0.646 true 0.792,0.406 1.104,0.563 0.313,0.156 10 *1 4.063,1.76 4.375,1.917 0.313,0.156 10 *2 3.313,0.406 3.625,0.563 0.313,0.156 10 *1 1.51,1.771 1.823,1.927 0.313,0.156 10 *2 0.469,0.458 0.927,0.656 0.458,0.198 10 (A)
*1 Housing Lock *2 Outer Housing




d.
B339277

Remove the bolt and door side airbag sensor LH.

NOTICE:

Loosen the bolt while holding the door side airbag sensor LH because the door side airbag sensor pin (stopper) is easily damaged.