1.INSTALL RADIO SETTING CONDENSER
Attach the claw to install a new terminal cover to the wire harness.
Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.
Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.
Do not use excessive force when inserting the wire harness into the terminal cover.
If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.
Attach the 3 claws to install the new terminal cover with wire harness to a new condenser.
Do not use excessive force when inserting the terminal cover into the condenser.
If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.
Attach the clamp to temporarily install a new radio setting condenser with wire harness.
Install the new radio setting condenser with the bolt.
64740E
2.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
62332C
3.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
67918E
4.INSTALL REAR DOOR SCUFF PLATE LH
5.INSTALL REAR SEAT ASSEMBLY
for LH:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY(for LH Side)>INSTALLATION
for RH:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY(for RH Side)>INSTALLATION
58577E
6.INSTALL REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE
w/o Spare Tire, for Compact Spare Tire:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
w/ Full Size Spare Tire:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
64716P
7.INSTALL REAR DECK TRIM COVER (w/ Full Size Spare Tire)
58386
8.INSTALL REAR FLOOR FINISH PLATE (w/o Spare Tire, for Compact Tire)
64997
9.INSTALL DECK FLOOR BOX LH
58410B
10.INSTALL DECK BOARD ASSEMBLY (w/ Full Size Spare Tire)
58410B
11.INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire, for Compact Tire)
64910N
12.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
64309A
13.INSTALL PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY (w/ Partition Net)