Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0050510 FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

·

If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.



HINT:
·

Use the same procedure for the driver side of RHD and LHD vehicles.

·

The procedures listed below are for the driver side of LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE FRONT SEAT ASSEMBLY LH

Hide 72526A 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

Hide 72495 5.REMOVE VERTICAL ADJUSTING HANDLE LH

Hide 71812D 6.REMOVE FRONT SEAT CUSHION SHIELD LH

Hide 71862 7.REMOVE FRONT INNER SEAT CUSHION SHIELD LH

Hide 8.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71931 9.REMOVE FRONT SEAT HEADREST SUPPORT

Hide 71074S 10.REMOVE SEPARATE TYPE FRONT SEATBACK COVER

Hide 71552S 11.REMOVE SEPARATE TYPE FRONT SEATBACK PAD

Hide 73920A 12.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH

a.
B339284

for Single Type:

i.

Detach the 2 clamps from the front seatback frame sub-assembly.


ii.

Remove the 2 nuts and front seat airbag assembly LH.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.





b.
B339285

for Dual Type:

i.

Detach the 2 clamps from the front seatback frame sub-assembly.


ii.

Remove the 2 nuts and front seat airbag assembly LH.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.