Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
72526A
1.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
| *1 | Protective Tape |
Using a screwdriver, detach the claw to remove the reclining adjuster release handle LH.
Tape the screwdriver tip before use.
72495
2.REMOVE VERTICAL ADJUSTING HANDLE LH
Remove the screw and vertical adjusting handle LH.
71812D
3.REMOVE FRONT SEAT CUSHION SHIELD LH
Detach the 2 clips and claw.
|
First |
|
Second |
Detach the claw and 3 guides to remove the front seat cushion shield LH as indicated by the arrows in the order shown in the illustration.
71862
4.REMOVE FRONT INNER SEAT CUSHION SHIELD LH
|
First |
|
Second |
Detach the 2 claws and 3 guides to remove the front inner seat cushion shield LH as indicated by the arrows in the order shown in the illustration.
71861
5.REMOVE FRONT INNER SEAT CUSHION SHIELD RH (for Front Passenger Side)
|
First |
|
Second |
Detach the 2 claws and 3 guides to remove the front inner seat cushion shield RH as indicated by the arrows in the order shown in the illustration.
6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Disconnect the rubber band.
| *1 | Wire Harness Clamp |
| *2 | Connector Clamp |
w/ Front Seat Side Airbag:
Detach the 4 wire clamps and connector clamp to disconnect the wire harness of the front seat side airbag.
| *1 | Fastener |
Detach the fastener to disconnect the wire harness of the front seat side airbag.
for Front Passenger Side, for Type B:
Remove the screw to disconnect the wire harness of the front seat inner belt assembly RH.
w/ Seat Heater System:
Detach the wire harness clamp and connector clamp.
Disconnect the connector.
Detach the 2 hooks.
Remove the 4 bolts and separate type front seatback assembly.
71931
7.REMOVE FRONT SEAT HEADREST SUPPORT
Detach the 4 claws to remove the 2 front seat headrest supports.
71074S
8.REMOVE SEPARATE TYPE FRONT SEATBACK COVER
Remove the 5 hog rings.
Remove the 3 hog rings.
for Sports Seat Type:
Open the 2 fasteners.
w/ Front Seat Side Airbag:
for Dual Type:
Remove the 2 nuts.
for Single Type:
Remove the nut.
Pull the separate type front seatback cover bracket from the separate type front seatback pad.
Remove the 8 hog rings and separate type front seatback cover from the separate type front seatback pad.
87510N
9.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)
71552S
10.REMOVE SEPARATE TYPE FRONT SEATBACK PAD
Remove the separate type front seatback pad from the separate type front seatback spring assembly LH.
79977A
11.REMOVE SEATBACK FELT
Remove the seatback felt from the separate type front seatback spring assembly LH.
73920A
12.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH (w/ Front Seat Side Airbag)
13.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
w/ Seat Heater System:
| *1 | Wire Harness Clamp |
| *2 | Connector Clamp |
Detach the 4 wire harness clamps and connector clamp to disconnect the wire harness of the front seat cushion heater.
for Driver Side:
Detach the 12 hooks to remove the separate type front seat cushion cover with pad.
for Front Passenger Side:
Detach the 11 hooks to remove the separate type front seat cushion cover with pad.
w/ Occupant Ditection Sensor:
Detach the clamp and disconnect the connector.
71072S
14.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
Remove the 21 hog rings and separate type front seat cushion cover from the separate type front seat cushion pad.
89178A
15.REMOVE SEAT POSITION AIRBAG SENSOR (w/ Occupant Classification System)
73905
16.REMOVE FRONT SEAT AIRBAG SUB-ASSEMBLY RH (for Front Passenger Side, w/ Occupant Classification System)
87510L
17.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)
73240
18.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
| *1 | Wire Harness Clamp |
| *2 | Connector Clamp |
for Type A:
Detach the 2 wire harness clamps and connector clamp.
for Type B:
| *1 | Wire Harness Clamp |
| *2 | Connector Clamp |
Detach the 3 wire harness clamps and connector clamp.
Detach the wire harness clamp.
Detach the 2 clamps.
Remove the nut and front seat inner belt assembly LH.
73230
19.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
for Type A:
| *1 | Wire Harness Clamp |
| *2 | Connector Clamp |
Detach the 3 wire harness clamps and connector clamp.
Detach the clamp.
Remove the nut and front seat inner belt assembly RH.
for Type B:
Disconnect the connector.
Detach the clamp.
Remove the nut and front seat inner belt assembly RH.
82191
20.REMOVE FRONT SEAT WIRE RH (for Front Passenger Side, w/ Occupant Classification System)
Disconnect the 4 connectors and detach the 6 clamps to remove the front seat wire RH.
89952
21.REMOVE OCCUPANT DETECTION ECU (for Front Passenger Side, w/ Occupant Classification System)
71874
22.REMOVE FRONT LOWER SEAT CUSHION SHIELD LH
Remove the screw.
Detach the hook in the direction indicated by the arrow in the illustration.
Detach the clip to remove the front lower seat cushion shield LH.
71873
23.REMOVE FRONT LOWER SEAT CUSHION SHIELD RH
Use the same procedure described for the front lower seat cushion shield LH.
71537D
24.REMOVE FRONT OUTER SEAT CUSHION EDGE PROTECTOR LH
Remove the front outer seat cushion edge protector LH in the direction indicated by the arrow in the illustration.
71538B
25.REMOVE FRONT INNER SEAT CUSHION EDGE PROTECTOR LH
Use the same procedure described for the front outer seat cushion edge protector LH.
71537C
26.REMOVE FRONT OUTER SEAT CUSHION EDGE PROTECTOR RH (for Front Passenger Side)
Remove the front seat outer cushion edge protector RH in the direction indicated by the arrow in the illustration.
71538A
27.REMOVE FRONT INNER SEAT CUSHION EDGE PROTECTOR RH (for Front Passenger Side)
Use the same procedure described for the front seat outer cushion edge protector RH.
72211
28.REMOVE SEAT TRACK ADJUSTING HANDLE
Detach the 2 hooks to remove the seat track adjusting handle in the direction indicated by the arrow in the illustration.
71849C
29.REMOVE SEAT ADJUSTER COVER CAP
Remove the 2 seat adjuster cover caps from the separate type front seat cushion spring assembly LH.