Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
Use the same procedure for the driver side of RHD and LHD vehicles.
The procedures listed below are for the driver side of LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
73920A
1.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH
for Single Type:
The nuts must not be reused.
Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
Install the front seat airbag assembly LH with 2 new nuts.
Attach the 2 clamps to the front seatback frame sub-assembly.
for Dual Type:
The nuts must not be reused.
Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
Install the front seat airbag assembly LH with 2 new nuts.
Attach the 2 clamps to the front seatback frame sub-assembly.
71552S
2.INSTALL SEPARATE TYPE FRONT SEATBACK PAD
71074S
3.INSTALL SEPARATE TYPE FRONT SEATBACK COVER
71931
4.INSTALL FRONT SEAT HEADREST SUPPORT
5.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
71862
6.INSTALL FRONT INNER SEAT CUSHION SHIELD LH
71812D
7.INSTALL FRONT SEAT CUSHION SHIELD LH
72495
8.INSTALL VERTICAL ADJUSTING HANDLE LH
72526A
9.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
10.INSTALL FRONT SEAT ASSEMBLY LH
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
12.PERFORM DIAGNOSTIC SYSTEM CHECK
13.CHECK SRS WARNING LIGHT