Home › Drivetrain › K111F MULTIDRIVE / CVT › OIL COOLER › 2012.12–2015.10
RM3090E _52 Drivetrain _009408 K111F MULTIDRIVE / CVT _0051018 OIL COOLER A

K111F MULTIDRIVE / CVT  OIL COOLER  INSTALLATION  


PROCEDURE

Hide 33493B 1.INSTALL OIL COOLER

a.

Install the oil cooler to the continuously variable transaxle assembly with the 3 bolts.

Torque:
13.5 N*m (138 kgf*cm, 10 ft.*lbf)


Hide 32941 2.INSTALL NO. 1 OIL COOLER INLET HOSE AND NO. 1 OIL COOLER OUTLET HOSE

C279766C01
1.271,0.438 1.927,0.156 1.927,0.156 2.344,0.156 false 0.427,1.344 0.427,0.365 0.427,0.365 0.552,0.365 false 0.771,2.667 0.552,2.302 0.552,2.302 0.365,2.302 false 2.177,3.073 3.073,3.052 3.073,3.052 3.073,2.75 false 2.417,0.083 2.771,0.417 0.354,0.333 10 false *b 0.625,0.281 1.021,0.615 0.396,0.333 10 false *b 0.198,2.208 0.552,2.552 0.354,0.344 10 false *a 1.99,2.99 2.333,3.271 0.344,0.281 10 false *c
*a White Paint Mark
*b Yellow Paint Mark
*c Pink Paint Mark


a.

Connect the 2 oil cooler hoses to the oil cooler and continuously variable transaxle assembly, and slide the 4 clamps to secure it.

NOTICE:

Make sure the pinching portion of each clip is facing the directions shown in the illustration and the paint marks are aligned as shown in the illustration.



Hide 16267H 3.CONNECT WATER BY-PASS HOSE

C279767C01
1.125,0.781 1.719,0.229 1.719,0.229 1.927,0.229 false 0.396,2.865 0.906,3.24 0.906,3.24 1.302,3.24 false 1.99,0.167 2.417,0.5 0.427,0.333 10 *a 1.375,3.146 1.719,3.396 0.344,0.25 10 *a
*a Yellow Paint Mark


a.

Connect the 2 water by-pass hoses to the oil cooler.

NOTICE:

Make sure the pinching portion of each clip is facing the directions shown in the illustration and the paint marks are aligned as shown in the illustration.



Hide 5.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 6.INSPECT FOR COOLANT LEAK