If automatic transmission parts are replaced, refer to the Parts Replacement Compensation Table to determine if any additional operations are necessary.
Click hereDrivetrain>U760F AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION
1.REMOVE DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT
Remove the flywheel housing under cover.
Using SST, hold the crankshaft pulley.
Remove the 6 drive plate and torque converter assembly setting bolts.
2.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
28100
3.REMOVE STARTER ASSEMBLY
4.DISCONNECT WIRE HARNESS
Remove the bolt and disconnect the ground cable from the automatic transaxle assembly.
Detach the 5 wire harness clamps.
Turn the lock lever and disconnect the connector from the wiring harness connector.
Disconnect the park/neutral position switch connector.
5.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the 2 bolts and 2 wire harness clamp bracket.
6.REMOVE BREATHER HOSE BRACKET
Detach the transmission breather hose sub-assembly from the breather hose bracket.
Remove the bolt and breather hose bracket from the automatic transaxle assembly.
82824
7.REMOVE WIRING HARNESS CONNECTOR
Remove the 2 bolts and wiring harness connector from the automatic transaxle assembly.
33493A
8.REMOVE TRANSMISSION OIL COOLER
Slide the clips and disconnect the oil cooler inlet hose and oil cooler outlet hose from the automatic transaxle assembly.
Remove the 2 bolts and transmission oil cooler from the front engine mounting bracket.
12311A
9.REMOVE FRONT ENGINE MOUNTING BRACKET
Remove the 4 bolts and front engine mounting bracket from the automatic transaxle assembly.
12321A
10.REMOVE REAR ENGINE MOUNTING BRACKET
Remove the 3 bolts and rear engine mounting bracket from the automatic transaxle assembly.
12325A
11.REMOVE ENGINE MOUNTING BRACKET LH
Remove the 4 bolts and engine mounting bracket LH from the automatic transaxle assembly.
33823
12.REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET
Remove the 2 bolts and No. 1 transmission control cable bracket from the automatic transaxle assembly.
35150
13.REMOVE TRANSMISSION CASE PLUG ASSEMBLY
Remove the transmission case plug assembly from the automatic transaxle assembly.
Remove the O-ring from the transmission case plug assembly.
30500
14.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
Remove the 9 bolts and automatic transaxle assembly.
To prevent damage to the knock pins, do not pry between the automatic transaxle assembly and engine.
15.REMOVE TORQUE CONVERTER ASSEMBLY
Remove the torque converter assembly from the automatic transaxle assembly.
Make sure to remove the torque converter assembly horizontally from the input shaft.
36100
16.REMOVE TRANSFER ASSEMBLY
36100A
17.REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT
Transfer Side:
Click hereDrivetrain>GF1A TRANSFER / 4WD / AWD>TRANSFER ASSEMBLY>DISASSEMBLY
Remove the 2 transfer and transaxle setting stud bolts.
It is not necessary to remove the transfer and transaxle setting stud bolts unless they are being replaced.
18.INSPECT TORQUE CONVERTER ASSEMBLY
19.INSPECT DRIVE PLATE