30500
1.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
36100
2.REMOVE TRANSFER ASSEMBLY
31105H
3.REMOVE TRANSAXLE CASE OIL SEAL RH
| *a | Protective Tape |
Outer:
Using a screwdriver with its tip wrapped with protective tape, pry out the transaxle case oil seal RH.
Be careful not to damage the housing.
Tape the screwdriver tip before use.
Inner:
Using SST, tap out the transaxle case oil seal RH.
Be careful not to damage the housing.
31105H
4.INSTALL TRANSAXLE CASE OIL SEAL RH
Inner:
Coat the lip of a new transaxle case oil RH seal with MP grease.
Using SST and a hammer, tap in the transaxle case oil seal RH.
21.5 to 22.5 mm (0.847 to 0.885 in.)
Outer:
Coat the lip of a new transaxle case oil seal RH with MP grease.
Using SST and a hammer, tap in the transaxle case oil seal RH.
5.5 to 6.5 mm (0.217 to 0.255 in.)
Make sure that the transaxle oil seal RH is installed in the correct direction.
36100
5.INSTALL TRANSFER ASSEMBLY
30500
6.INSTALL AUTOMATIC TRANSAXLE ASSEMBLY