1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure toread the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
4.DRAIN ENGINE COOLANT
5.DRAIN AUTOMATIC TRANSAXLE FLUID
74404A
6.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28899
7.REMOVE BATTERY INSULATOR
28800
8.REMOVE BATTERY
74431
9.REMOVE BATTERY TRAY
74411B
10.REMOVE FRONT BATTERY BRACKET
74414B
11.REMOVE BATTERY BRACKET REINFORCEMENT
33493A
12.REMOVE TRANSMISSION OIL COOLER
Slide the clips and remove the oil cooler inlet hose and oil cooler outlet hose.
Detach the 3 clamps from the No. 8 water by-pass hose and No. 9 water by-pass hose.
Slide the clips and remove the No. 8 water by-pass hose and No. 9 water by-pass hose.
Remove the 2 bolts and transmission oil cooler from the front engine mounting bracket.