Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE(for Dual Type)
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0059591 SPIRAL CABLE(for Dual Type) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE(for Dual Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 45286 5.REMOVE STEERING COLUMN COVER

Hide 84306 6.REMOVE SPIRAL CABLE SUB-ASSEMBLY

NOTICE:
·

Do not replace the spiral cable with the battery connected and the ignition switch on (IG).

·

Do not rotate the spiral cable with the battery connected and the ignition switch on (IG).

·

Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.



a.
B341165C02
0.792,2.625 2.052,3.031 true 2.115,2.979 2.427,3.135 0.313,0.156 10 *1
*1 Slider


Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable sub-assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



b.

Disconnect the connector from the spiral cable sub-assembly.


c.
B341169

Detach the 3 claws to remove the spiral cable sub-assembly.