Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SRS SEAT CUSHION AIRBAG ASSEMBLY
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0059593 SRS SEAT CUSHION AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  SRS SEAT CUSHION AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

·

If the cushion airbag was deployed, replace the front seat airbag sub-assembly RH, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with the necessary parts in accordance with the extent of the collision damage.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE FRONT SEAT ASSEMBLY RH

Hide 72525A 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

Hide 71811D 5.REMOVE FRONT SEAT CUSHION SHIELD RH

Hide 71861 6.REMOVE FRONT INNER SEAT CUSHION SHIELD RH

Hide 7.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 8.REMOVE SEPARATE TYPE SEAT CUSHION COVER WITH PAD

Hide 73905 9.REMOVE FRONT SEAT AIRBAG SUB-ASSEMBLY RH

a.

Detach the 3 clamps from the separate type front seat cushion spring assembly.

CAUTION:
·

The nuts must not be reused.

·

Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.




b.

Remove the 3 nuts and front seat airbag sub-assembly RH.

B341155