Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SRS SEAT CUSHION AIRBAG ASSEMBLY
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0059593 SRS SEAT CUSHION AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  SRS SEAT CUSHION AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

·

If the cushion airbag was deployed, replace the front seat airbag sub-assembly RH, separate type front seat cushion spring assembly, separate type front seat cushion cover and separate type front seat cushion pad with the necessary parts in accordance with the extent of the collision damage.



PROCEDURE

Hide 73905 1.INSTALL FRONT SEAT AIRBAG SUB-ASSEMBLY RH

a.

Install the front seat airbag assembly LH with 3 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

CAUTION:
·

The nuts must not be reused.

·

Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.




b.

Attach the 3 clamps to the separate type front seat cushion spring assembly.


Hide 2.INSTALL SEPARATE TYPE SEAT CUSHION COVER WITH PAD

Hide 3.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY

Hide 71861 4.INSTALL FRONT INNER SEAT CUSHION SHIELD RH

Hide 71811D 5.INSTALL FRONT SEAT CUSHION SHIELD RH

Hide 72525A 6.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION