Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR
RM3090E _58 Vehicle Interior _008786 SUPPLEMENTAL RESTRAINT SYSTEMS _0059594 SEAT POSITION SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SEAT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ Occupant Classification System)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE FRONT SEAT ASSEMBLY LH

Hide 72526A 4.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)

Hide 72495 5.REMOVE VERTICAL ADJUSTING HANDLE LH (for Manual Seat)

Hide 71812D 6.REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)

Hide 89178A 7.REMOVE SEAT POSITION AIRBAG SENSOR

a.
B341154

for Manual Seat:

i.

Disconnect the connector.


ii.

Separate the wire harness from the seat slide position sensor protector.


iii.

Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor with the seat slide position sensor protector.



b.
B345211

for Power Seat:

i.

Disconnect the connector.


ii.

Separate the wire harness from the seat slide position sensor protector.


iii.

Using a T30 "TORX" socket wrench, remove the "TORX" screw and seat position airbag sensor with the seat slide position sensor protector.



c.
B228031

Remove the seat position airbag sensor from the seat slide position sensor protector as shown in the illustration.