The fuel injector assemblies are located on the intake port. They inject fuel into the cylinders based on the signals from the ECM.
Inspect the fuses for circuits related to this system before performing the following procedure.
| *a | Front view of wire harness connector
(to Fuel Injector Assembly) |
Disconnect the fuel injector assembly connectors.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| B19-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B17-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B15-1 - Body ground | Ignition switch ON | 11 to 14 V |
| B13-1 - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the fuel injector assembly injection and volume.
Click hereEngine / Hybrid System>2AR-FE FUEL>FUEL INJECTOR>INSPECTION
Perform "Inspection After Repair" after replacing the fuel injector assembly.
Click hereEngine / Hybrid System>2AR-FE ENGINE CONTROL>SFI SYSTEM(w/ Canister Pump Module)>INITIALIZATION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the fuel injector assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B19-2 - B77-20 (#10) | Always | Below 1 Ω |
| B17-2 - B77-17 (#20) | Always | Below 1 Ω |
| B15-2 - B77-18 (#30) | Always | Below 1 Ω |
| B13-2 - B77-19 (#40) | Always | Below 1 Ω |
| B19-2 or B77-20 (#10) - Body ground | Always | 10 kΩ or higher |
| B17-2 or B77-17 (#20) - Body ground | Always | 10 kΩ or higher |
| B15-2 or B77-18 (#30) - Body ground | Always | 10 kΩ or higher |
| B13-2 or B77-19 (#40) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the fuel injector assembly connector.
Remove the IG2 relay from the engine room relay block and junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B19-1 - IG2 relay terminal 5 | Always | Below 1 Ω |
| B17-1 - IG2 relay terminal 5 | Always | Below 1 Ω |
| B15-1 - IG2 relay terminal 5 | Always | Below 1 Ω |
| B13-1 - IG2 relay terminal 5 | Always | Below 1 Ω |
| B19-1, B17-1, B15-1, B13-1 or IG2 relay terminal 5 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG