The combination meter assembly illuminates, blinks or turns off the front seat belt warning light on the combination meter assembly in accordance with the state of the front seat inner belt assembly LH.
The front seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat.
The seat belt warning system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure.
Clear the DTCs.
Check for DTCs.
| Proceed to |
|---|
| DTCs are not output |
| DTCs are output |
DTCs are not output
DTCs are output
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / SRS Airbag / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Left side Buckle SW | Driver side buckle switch | Unset, Set or NG | Unset: Front seat belt LH not fastened
Set: Front seat belt LH fastened NG: Data is not determined |
- |
| Tester Display |
|---|
| Left side Buckle SW |
| Result | Proceed to |
|---|---|
| Unset or Set is displayed on the GTS screen according to the driver side seat belt condition | A |
| Unset or Set is not displayed normally on the GTS screen according to the driver side seat belt condition | B |
| NG is displayed on the GTS screen | C |
A
B
C
Replace the main body ECU (multiplex network body ECU) with a new or normally one.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check the operation of the front seat belt warning light.
| Proceed to |
|---|
| The front seat belt warning light operates normally |
| The front seat belt warning light does not operate normally |
The front seat belt warning light operates normally
The front seat belt warning light does not operate normally