Use the following procedure to troubleshoot the parking assist monitor system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the navigation system.
| Proceed to |
|---|
| Navigation system is normal |
| Navigation system is abnormal |
Navigation system is normal
Navigation system is abnormal
Use the GTS to check if the CAN communication system is functioning normally.
| Proceed to |
|---|
| CAN DTCs are not output. |
| CAN DTCs are output. |
CAN DTCs are not output.
CAN DTCs are output.
Check for DTCs and note any codes that are output.
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
The navigation ECU sub-assembly outputs DTCs for the following systems. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.
| Proceed to |
|---|
| No DTCs are output. |
| DTCs for parking assist monitor system are output. |
| DTCs for navigation system are output. |
No DTCs are output.
DTCs for parking assist monitor system are output.
DTCs for navigation system are output.
Refer to the Problem Symptoms Table.
| Proceed to |
|---|
| Fault is not listed in Problem Symptoms Table |
| Fault is listed in Problem Symptoms Table |
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table
Data List / Active Test.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT