Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE BOOSTER(for RHD) › 2013.11–2015.10
RM3090E _54 Brake _008768 BRAKE SYSTEM (OTHER) _0049562 BRAKE BOOSTER(for RHD) A

BRAKE SYSTEM (OTHER)  BRAKE BOOSTER(for RHD)  INSTALLATION  


PROCEDURE

Hide 44696 1.INSTALL VACUUM SENSOR GROMMET (for 1AD-FTV 2WD)

a.

Install the vacuum sensor grommet to the brake booster.


Hide 89420H 2.INSTALL VACUUM SENSOR ASSEMBLY (for 1AD-FTV 2WD)

a.

Install the vacuum sensor to the vacuum sensor grommet.


Hide 44696 3.INSTALL CHECK VALVE GROMMET

a.

Install a new check valve grommet to the brake booster.


Hide 44730 4.INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY

a.

Install the brake vacuum check valve to the check valve grommet.


Hide 44785 5.INSTALL BRAKE BOOSTER GASKET

a.

Install a new brake booster gasket to the brake booster.


Hide 47264D 6.INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS

a.

Install the push rod clevis to the brake booster.


Hide 44610 7.INSTALL BRAKE BOOSTER ASSEMBLY

a.

Install the brake booster with the 4 nuts.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)

NOTICE:

Do not damage the brake tubes.



Hide 47264A 8.INSTALL PUSH ROD PIN

Hide 47101A 9.INSTALL BRAKE PEDAL RETURN SPRING

Hide 10.CHECK AND ADJUST BRAKE BOOSTER PUSH ROD

Hide 11.CONNECT VACUUM HOSE

a.

Connect the vacuum hose with the clip.


Hide 47201 12.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

Hide 73900 13.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55432B 14.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)

Hide 55735C 15.INSTALL COWL BODY MOUNTING REINFORCEMENT RH

a.

Install the cowl body mounting reinforcement RH with the 2 nuts.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 55701J 16.INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY

a.

Install the cowl top panel outer sub-assembly with the 13 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 55081E 17.INSTALL COWL VENTILATOR HOUSING SUB-ASSEMBLY

a.

Engage the 3 clips to install the cowl ventilator housing sub-assembly.


Hide 85160 18.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 20.BLEED BRAKE SYSTEM

Hide 22.CHECK AND ADJUST BRAKE PEDAL