Home › Drivetrain › EA64F MANUAL TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE › 2013.11–2014.10
RM3090E _52 Drivetrain _008756 EA64F MANUAL TRANSMISSION / TRANSAXLE _0050294 TRANSMISSION CONTROL CABLE A

EA64F MANUAL TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  REMOVAL  


PROCEDURE

Hide 58901A 1.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

Hide 33820B 2.DISCONNECT TRANSAXLE CONTROL CABLE ASSEMBLY

C284485C01
0.885,2.427 1.156,2.427 1.156,2.427 1.302,2.01 true 1.906,2.01 2.177,2.385 2.177,2.385 2.406,2.385 true 0.604,2.333 0.823,2.563 0.219,0.229 10 true *1 2.521,2.292 2.74,2.521 0.219,0.229 10 true *2
*1 Select Control Cable
*2 Shift Control Cable


a.

Remove the clip and disconnect the cable end of the select control cable from the floor shift shift lever assembly.


b.

Push the ends of the clip apart, and then disconnect the shift control cable from the floor shift shift control cable assembly.


c.
C284488C01
0.635,1.448 0.969,1.448 0.969,1.448 1.125,1.135 false 1.938,0.656 2.146,0.344 2.146,0.344 2.427,0.344 false 2.521,0.281 2.833,0.479 0.313,0.198 10 false *1 0.375,1.375 0.688,1.573 0.313,0.198 10 false *2
*1 Cable Lock
*2 Lock Nut


Using a screwdriver, pull out the cable locks of the shift control cable and select control cable.


d.

Rotate the nut clockwise approximately 180° and, while holding the nut in that position, disconnect the shift control cable and select control cable from the floor shift shift lever assembly.

NOTICE:

Do not over-rotate the cable lock as it will come off the internal spring and the transaxle control cable assembly will not be reusable.



e.

Remove the shift control cable from the floor shift lever assembly while holding the lock nut.


Hide 17119A 4.REMOVE AIR CLEANER BRACKET

Hide 5.DISCONNECT ENGINE WIRE

C278035

a.

Remove the bolt, clamp and engine wire.


Hide 33820B 6.REMOVE TRANSAXLE CONTROL CABLE ASSEMBLY

C127238C01
1.813,0.896 1.427,0.396 1.427,0.396 1.052,0.396 false 1.833,0 1.677,0 false 1.917,1.01 2.292,1.49 2.292,1.49 2.573,1.49 false 0.813,0.344 1.083,0.552 0.271,0.208 10 *1 2.667,1.438 2.958,1.656 0.292,0.219 10 *2
*1 Select Control Cable
*2 Shift Control Cable


a.

Removal the 2 clips and disconnect the top ends of the transaxle control cable assembly from the manual transaxle assembly.


b.

Remove the 2 clips and disconnect the control cable bracket.


c.
C127242

Remove the 2 bolts from the retainer.


d.

Pull out the transaxle control cable assembly from the floor.