Home › Engine / Hybrid System › 1AD-FTV INTAKE / EXHAUST › EXHAUST PIPE › 2014.10–2015.10
RM3090E _51 Engine / Hybrid System _008376 1AD-FTV INTAKE / EXHAUST _0046749 EXHAUST PIPE A

1AD-FTV INTAKE / EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 17410 2.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.

Check the free length of the compression spring.

i.
A128853

Using a vernier caliper, measure the free length of the compression spring.

Minimum length:

41.5 mm (1.63 in.)


If the free length is less than the minimum, replace the compression spring.



b.
A291393C02
2.417,1.083 3.083,1.083 true 0.917,1.917 1.083,1.917 1.083,1.917 2.042,1.583 true 0.771,1.813 1.083,1.969 0.313,0.156 10 false *1 3.115,0.979 3.427,1.135 0.313,0.156 10 false *a
*1 Gasket
*a Wooden Block


Using a hammer and wooden block, tap on a new gasket until its surface is flush with the exhaust manifold converter sub-assembly.

NOTICE:
·

Install the gasket in the correct direction.

·

Do not reuse the gasket.

·

Do not damage the gasket by dropping it, etc.

·

Do not damage the outer surface of the gasket.

·

Do not push on the gasket with the front exhaust pipe assembly when connecting it.




c.

Connect the front exhaust pipe assembly to the 3 exhaust pipe supports.


d.

Install the front exhaust pipe assembly and 2 compression springs with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 51442 3.INSTALL NO. 2 ENGINE UNDER COVER

Hide 50819 4.INSTALL FRONT FLOOR COVER

Hide 17430 5.INSTALL TAILPIPE ASSEMBLY

a.

Check the free length of the compression spring.

i.
A128853

Using a vernier caliper, measure the free length of the compression spring.

Minimum length:

38.5 mm (1.52 in.)


If the free length is less than the minimum, replace the compression spring.



b.
A291393C02
2.417,1.083 3.083,1.083 true 0.917,1.917 1.083,1.917 1.083,1.917 2.042,1.583 true 0.771,1.813 1.083,1.969 0.313,0.156 10 false *1 3.115,0.979 3.427,1.135 0.313,0.156 10 false *a
*1 Gasket
*a Wooden Block


Using a hammer and wooden block, tap on a new gasket until its surface is flush with the front exhaust pipe assembly.

NOTICE:
·

Install the gasket in the correct direction.

·

Do not reuse the gasket.

·

Do not damage the gasket by dropping it, etc.

·

Do not damage the outer surface of the gasket.

·

Do not push on the gasket with the tailpipe assembly when connecting it.




c.

Connect the tailpipe assembly to the 2 exhaust pipe supports.


d.

Install the tailpipe assembly and 2 compression springs with the 2 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 6.INSPECT FOR EXHAUST GAS LEAK

a.

Check that there are no exhaust gas leaks from the points (connection areas of the exhaust pipes and installation areas of each sensor).