The navigation ECU and the radio and display receiver assembly are connected by the LVDS communication line.
This DTC is stored when an LVDS communication error occurs between the navigation ECU and the radio and display receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1532 | LVDS Signal Malfunction (from Extension Module) | When one of the conditions below is met:
·
Video signal (digital) is lost. ·
Navigation ECU is/was not connected while the ignition switch is/was to ON or ACC. ·
Communication between the master unit and the navigation ECU is/was not possible when the engine is/was started. |
·
Navigation ECU power source circuit ·
LVDS circuit between radio and display receiver assembly and navigation ECU ·
Navigation ECU ·
Radio and display receiver assembly ·
No. 1 navigation wire |
Even if no fault is present, this DTC may be stored depending on the battery condition or engine start voltage.
The radio and display receiver assembly is the master unit.
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| *a | Front view of wire harness connector
(to Navigation ECU) |
Disconnect the navigation ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Y5-2 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Y5-1 (B+) - Y5-2 (GND) | Always | 11 to 14 V |
| Y5-3 (ACC) - Y5-2 (GND) | Ignition switch ACC | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the No. 1 navigation wire (LVDS communication line).
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ECU>REMOVAL
Clear the DTCs.
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the Y1 radio and display receiver assembly connector.
Disconnect the Y5 navigation ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Y1-4 (+B2) - Y5-1 (B+) | Always | Below 1 Ω |
| Y1-3 (ACC2) - Y5-3 (ACC) | Always | Below 1 Ω |
| Y1-8 (GND2) - Y5-2 (GND) | Always | Below 1 Ω |
| Y1-4 (+B2) - Body ground | Always | 10 kΩ or higher |
| Y1-3 (ACC2) - Body ground | Always | 10 kΩ or higher |
| Y1-8 (GND2) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the navigation ECU with a known good one.
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ECU>REMOVAL
Clear the DTCs.
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG