Home › Drivetrain › K111F MULTIDRIVE / CVT › TRANSMISSION CONTROL CABLE › from 2014.10
RM3090E _52 Drivetrain _009408 K111F MULTIDRIVE / CVT _0051022 TRANSMISSION CONTROL CABLE A

K111F MULTIDRIVE / CVT  TRANSMISSION CONTROL CABLE  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

Hide 11212 2.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected.


Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION

Hide 74404A 4.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 28800 5.REMOVE BATTERY

Hide 74431 6.REMOVE BATTERY TRAY

Hide 74411B 7.REMOVE FRONT BATTERY BRACKET

Hide 74414B 8.REMOVE BATTERY BRACKET REINFORCEMENT

Hide 17705 9.REMOVE AIR CLEANER CAP AND HOSE

Hide 17701 10.REMOVE AIR CLEANER CASE

Hide 58901A 12.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

Hide 13.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C203403

Disconnect the end of the transmission control cable assembly from the shift lever.


c.
C127813C02
2.168,0.068 2.379,0.274 0.211,0.206 10 *1 0.945,0.221 1.156,0.426 0.211,0.206 10 *2 1.809,0.669 2.059,0.162 2.059,0.162 2.157,0.162 false 1.49,0.808 1.24,0.301 1.24,0.301 1.142,0.301 false
*1 Stopper
*2 Nut


Pull out the stopper of the transmission control cable assembly.


d.

Rotate the nut of the transmission control cable assembly counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever retainer.

NOTICE:

Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.



e.
C279770

Remove the nut and disconnect the control cable assembly from the control shaft lever.


f.

Remove the clip and disconnect the transmission control cable assembly from the control cable bracket.


g.
C201443

Disconnect the transmission control cable assembly from the control cable support.


h.
C131876

Remove the bolt and disconnect the clamp of the transmission control cable assembly.


i.
C127837

Remove the 2 bolts and disconnect the transmission control cable assembly.


j.

Pull out the transmission control cable assembly to remove it.