Home › Engine / Hybrid System › 3ZR-FAE ENGINE MECHANICAL › DRIVE BELT › from 2015.04
RM3090E _51 Engine / Hybrid System _008387 3ZR-FAE ENGINE MECHANICAL _0046810 DRIVE BELT G

3ZR-FAE ENGINE MECHANICAL  DRIVE BELT  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 16361A 1.INSPECT V-RIBBED BELT

a.
A122920

Check the belt for wear, cracks or other signs of damage.

If any of the following defects is found, replace the V-ribbed belt.

·

The belt is cracked.

·

The belt is worn out to the extent that the cords are exposed.

·

The belt has chunks missing from the ribs.



b.
A141644C03
0.521,1.344 0.833,1.5 0.313,0.156 10 *a 2.354,1.344 2.667,1.5 0.313,0.156 10 *b
*a CORRECT
*b INCORRECT


Check that the belt fits properly in the ribbed grooves.

HINT:

Check with your hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley. If it has slipped out, replace the V-ribbed belt. Install a new V-ribbed belt correctly.



Hide 16620 2.INSPECT V-RIBBED BELT TENSIONER ASSEMBLY


b.

Check that nothing is caught in the V-ribbed belt tensioner assembly by turning it clockwise and counterclockwise.

HINT:

If a malfunction exists, replace the V-ribbed belt tensioner assembly.