16361A
1.INSTALL V-RIBBED BELT
Set the V-ribbed belt onto every pulley.
Attach a wrench to the hexagonal portion (A) or (B) of the V-ribbed belt tensioner assembly as shown in the illustration, and while rotating the V-ribbed belt tensioner assembly clockwise, remove the 5 mm bi-hexagon wrench.
Check that the V-ribbed belt is properly set to each pulley.
16361A
2.INSPECT V-RIBBED BELT
51443
3.INSTALL REAR ENGINE UNDER COVER RH
Install the rear engine under cover RH with the 4 clips.
11212
4.INSTALL NO. 2 CYLINDER HEAD COVER