Home › Engine / Hybrid System › 3ZR-FAE ENGINE CONTROL › ECM › from 2015.04
RM3090E _51 Engine / Hybrid System _008381 3ZR-FAE ENGINE CONTROL _0046858 ECM A

3ZR-FAE ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 11212 3.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 17705 4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

a.
A293342

Detach the wire harness clamp from the air cleaner case sub-assembly.


b.

Remove the 3 bolts and air cleaner case sub-assembly.


Hide 89661 6.REMOVE ECM

a.

Disconnect the 2 ECM connectors.

NOTICE:

After disconnecting a connector, make sure that dirt, water or other foreign matter does not contact the connector.


i.
A347893C01
0.292,1.177 0.292,1 0.292,1 0.563,0.771 true 0.281,2.781 0.281,2.604 0.281,2.604 0.635,2.427 true 0.646,0.219 0.844,0.396 0.198,0.177 10 true *a 0.208,2.792 0.417,2.979 0.208,0.188 10 false *b 0.229,1.188 0.438,1.385 0.208,0.198 10 false *b 0.719,1.854 0.917,2.031 0.198,0.177 10 true *a
*a Push
*b Lock


Move the 2 levers as shown in the illustration while pushing the locks on the 2 levers and disconnect the 2 ECM connectors.



b.
A346174

Remove the 3 bolts and ECM.


Hide 89667E 7.REMOVE NO. 1 ECM BRACKET

a.
A293346

Remove the 2 screws and No. 1 ECM bracket.


Hide 89668 8.REMOVE NO. 2 ECM BRACKET

a.
A346175

Remove the 2 screws and No. 2 ECM bracket.