Home › Engine / Hybrid System › 2WW ENGINE CONTROL › ECD SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208480 ECD SYSTEM C

2WW ENGINE CONTROL  ECD SYSTEM  P2138  Throttle / Pedal Position Sensor / Switch "D"/"E" Voltage Correlation  


DESCRIPTION

Refer to DTC P2122.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>P060D

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P2138 Throttle / Pedal Position Sensor / Switch "D"/"E" Voltage Correlation The difference between VPA and VPA2 is less than 0.45 V for 0.5 seconds.
(1 trip detection logic)
Accelerator pedal sensor assembly Comes on DTC stored

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

When replacing the ECM, the ECM needs registration and initialization.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>PRECAUTION


HINT:
·

When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.

·

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.



PROCEDURE

1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2138)
a.

Connect the GTS to the DLC3.


b.

Start the engine and turn the GTS on.


c.

Allow the engine to idle for 1 minute or more.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 371

e.

Read the DTCs.

Result:
Result Proceed to
DTC P2138 A
DTC P2138 and other DTCs B


HINT:

If any DTCs other than P2138 are output, troubleshoot those DTCs first.




A

2.REPLACE ACCELERATOR PEDAL SENSOR ASSEMBLY

B

2.REPLACE ACCELERATOR PEDAL SENSOR ASSEMBLY
a.

Replace the accelerator pedal sensor assembly.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ACCELERATOR PEDAL>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine and ECT > Clear DTCs
50002 371

d.

Turn the ignition switch off and wait for 60 seconds or more.


e.

Turn the ignition switch to ON.


f.

Depress and release the accelerator pedal slowly and completely several times.


g.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 371

h.

Confirm that the DTC is not output again.


Result:
Proceed to
NEXT



NEXT

END