Home › Engine / Hybrid System › 2WW ENGINE CONTROL › ECM › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208482 ECM A

2WW ENGINE CONTROL  ECM  REMOVAL  


PROCEDURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

a.
A373153

Disconnect the mass air flow meter connector and detach the wire harness clamp.


b.

Detach the 2 clamps.


c.

Loosen the hose clamp and remove the air cleaner cap sub-assembly.


Hide 17801 5.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 6.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

a.
A373154

Remove the 3 bolts and air cleaner case sub-assembly.


Hide 89661A 7.REMOVE ECM

a.
A373155C01
0,0 0,0 false
V100135

Push
V100136

Raise


Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.



b.
A373156

Detach the claw and disconnect the relay.


c.

Remove the 3 bolts and ECM.

NOTICE:

Avoid physical shock to the ECM.



d.
A373157

Remove the 2 screws and No. 1 ECM bracket from the ECM.


e.
A373158

Remove the 2 screws and No. 2 ECM bracket from the ECM.