Home › Engine / Hybrid System › 2WW ENGINE CONTROL › CAMSHAFT POSITION SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208485 CAMSHAFT POSITION SENSOR A

2WW ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL CAMSHAFT POSITION SENSOR

a.

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:
·

When reusing the camshaft position sensor, inspect the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.




b.

Using an E6 "TORX" socket wrench, install the camshaft position sensor with the bolt.

Torque:
3.6 N*m (37 kgf*cm, 32 in.*lbf)

NOTICE:
·

Avoid physical shock to the camshaft position sensor.

·

Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.




c.

Connect the camshaft position sensor connector.