Home › Engine / Hybrid System › 2WW ENGINE CONTROL › INTAKE AIR TEMPERATURE SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208488 INTAKE AIR TEMPERATURE SENSOR A

2WW ENGINE CONTROL  INTAKE AIR TEMPERATURE SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 4.REMOVE INTAKE AIR TEMPERATURE SENSOR

a.
A315745

Disconnect the intake air temperature sensor connector.


b.
A354292N01
0.833,1.708 1.083,1.906 0.25,0.198 10 true 45°

Rotate the intake air temperature sensor 45° counterclockwise and remove it.

NOTICE:

Avoid physical shock to the intake air temperature sensor.