Home › Engine / Hybrid System › 2WW ENGINE CONTROL › AIR FUEL RATIO SENSOR(for Sensor 1) › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208490 AIR FUEL RATIO SENSOR(for Sensor 1) A

2WW ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "O2 Sensor Learning Value Reset" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION


a.
A373168C01
1.896,0.906 2.375,0.208 2.375,0.208 2.542,0.208 true 1.156,0.375 1.469,0.531 0.313,0.156 10 false *a 2.604,0.125 3.063,0.323 0.458,0.198 10 false SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00011  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

NOTICE:

Avoid physical shock to the air fuel ratio sensor.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.04 in.)): 44.7 N*m (456 kgf*cm, 33 ft.*lbf)




b.
A340622C02
1.479,2.51 1.771,2.24 1.771,2.24 2.51,2.469 false 1.177,2.969 1.073,3.104 1.073,3.104 2.333,2.948 false 1.688,2.063 2,2.219 0.313,0.156 10 false *1 0.917,3.01 1.229,3.167 0.313,0.156 10 false *2 3.083,2.271 3.396,2.427 0.313,0.156 10 false *a
*1 Air Fuel Ratio Sensor Connector
*2 Bracket
*a 1.5 mm (0.0591 in.) or less


Lower the air fuel ratio sensor connector to the position shown in the illustration and connect the air fuel ratio sensor connector.


c.

Attach the 2 clamps.


Hide 4. PERFORM INITIALIZATION

a.

Perform "O2 Sensor Learning Value Reset" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION