Home › Engine / Hybrid System › 2WW ENGINE CONTROL › AIR FUEL RATIO SENSOR(for Sensor 2) › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208491 AIR FUEL RATIO SENSOR(for Sensor 2) A

2WW ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 2)  INSTALLATION  


PROCEDURE

Hide 89467C 1.INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "O2 Sensor Learning Value Reset" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION


a.
A357479C01
1.667,0.958 1.927,1.667 1.927,1.667 2.333,1.667 true 2.344,0.375 2.656,0.531 0.313,0.156 10 false *a 2.375,1.563 2.833,1.76 0.458,0.198 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor.

SST
09224-00011  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

NOTICE:

Avoid physical shock to the air fuel ratio sensor connector.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.04 in.)): 44.7 N*m (456 kgf*cm, 33 ft.*lbf)




b.

Attach the 2 clamps.


c.
A340627C01
1.469,2.521 1.979,2.281 1.979,2.281 2.594,2.521 false 1.25,3.01 1.031,3.135 1.031,3.135 2.427,2.938 true 1.896,2.094 2.208,2.25 0.313,0.156 10 false *a 0.865,3.021 1.177,3.177 0.313,0.156 10 false *b 3.073,2.781 3.385,2.938 0.313,0.156 10 false *c
*a Air Fuel Ratio Sensor Connector
*b Bracket
*c 1.5 mm (0.0591 in.) or less


Attach the air fuel ratio sensor connector to the bracket as shown in the illustration and connect the air fuel ratio sensor connector.


Hide 51442 3.INSTALL FRONT NO. 2 ENGINE UNDER COVER

Hide 4. PERFORM INITIALIZATION

a.

Perform "O2 Sensor Learning Value Reset" after replacing the air fuel ratio sensor.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION