Home › Engine / Hybrid System › 2WW EMISSION CONTROL › EXHAUST MANIFOLD PRESSURE SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210867 EXHAUST MANIFOLD PRESSURE SENSOR A

2WW EMISSION CONTROL  EXHAUST MANIFOLD PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL EXHAUST MANIFOLD PRESSURE SENSOR

a.

Apply a light coat of engine oil to the O-ring of the exhaust manifold pressure sensor.


b.

Using a 27 mm deep socket wrench, install the exhaust manifold pressure sensor.

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the exhaust manifold pressure sensor.

·

Be careful not to damage the O-ring when installing the exhaust manifold pressure sensor.




c.

Connect the exhaust manifold pressure sensor connector.


Hide 17880 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY