Home › Engine / Hybrid System › 2WW COOLING › WATER PUMP › from 2015.10
RM3090E _51 Engine / Hybrid System _044377 2WW COOLING _0211206 WATER PUMP A

2WW COOLING  WATER PUMP  INSTALLATION  


PROCEDURE

Hide 16100 1.INSTALL ENGINE WATER PUMP ASSEMBLY

a.
A251393

Apply seal packing in a continuous line as shown in the illustration.

Standard seal diameter:

2.0 to 2.5 mm (0.0787 to 0.0984 in.)


NOTICE:
·

Remove any oil from the contact surface.

·

Install the engine water pump assembly within 3 minutes of applying seal packing.

·

Do not start the engine for at least 4 hours after installation.




b.

Install the engine water pump assembly with the 5 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 27020 2.INSTALL GENERATOR ASSEMBLY