Home › Power Source / Network › 2WW BATTERY / CHARGING › GENERATOR › from 2015.10
RM3090E _57 Power Source / Network _044381 2WW BATTERY / CHARGING _0212676 GENERATOR A

2WW BATTERY / CHARGING  GENERATOR  INSTALLATION  


PROCEDURE

Hide 27020 1.INSTALL GENERATOR ASSEMBLY

a.
A370610N01
1.208,1.75 1.51,1.75 true 1.021,1.635 1.177,1.833 0.156,0.198 10 true A

Using an E12 "TORX" socket wrench, install the generator assembly with the 2 bolts.

Torque:
38 N*m (387 kgf*cm, 28 ft.*lbf)

HINT:

Install the generator assembly with bolt A inserted as shown in the illustration.



b.

Connect the generator wire with the nut.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


c.

Install the terminal cap.


d.

Connect the generator connector.


Hide 2.INSTALL FAN AND GENERATOR V BELT

Hide 3.INSTALL REAR ENGINE UNDER COVER RH

Hide 5.INSTALL CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION