Home › Engine / Hybrid System › 2WW ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › from 2015.10
RM3090E _51 Engine / Hybrid System _044373 2WW ENGINE MECHANICAL _0211287 REAR CRANKSHAFT OIL SEAL A

2WW ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 31210 2.REMOVE CLUTCH COVER ASSEMBLY

Hide 31250 3.REMOVE CLUTCH DISC ASSEMBLY

Hide 13450 4.REMOVE FLYWHEEL WITH DAMPER ASSEMBLY

a.
A315454E01
2.5,1.917 2.333,1.917 2.333,1.917 1.906,1.427 true 2.594,1.833 3.052,2.031 0.458,0.198 10 false SST

Using SST, secure the flywheel with damper assembly.

SST:

PZ4TB-04939-38



b.
A315455E01
2,1.219 2.583,0.667 2.583,0.667 2.75,0.667 true 2.813,0.583 3.271,0.781 0.458,0.198 10 false SST

Using SST, remove the 8 bolts and flywheel with damper assembly.

SST:

PZ4TB-04910-18



c.

Remove SST.


d.
A358352

Remove the crankshaft position sensor plate from the crankshaft.


Hide 11401L 5.REMOVE REAR ENGINE OIL SEAL

a.
A315457C01
2.25,1.417 2.74,0.927 2.74,0.927 2.906,0.927 true 2.99,0.833 3.302,1.031 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver, pry out the rear engine oil seal.

NOTICE:

Do not damage the rear engine oil seal press fit hole, crankshaft or the surface of the timing chain cover plate.


HINT:

Tape the screwdriver tip before use.