Home › Engine / Hybrid System › 2WW ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › from 2015.10
RM3090E _51 Engine / Hybrid System _044373 2WW ENGINE MECHANICAL _0211287 REAR CRANKSHAFT OIL SEAL A

2WW ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11401L 1.INSTALL REAR ENGINE OIL SEAL

a.
A318529E01
2.427,0.885 2.854,0.75 2.854,0.75 2.667,1.125 true 2.917,0.646 3.375,0.844 0.458,0.198 10 false SST

Using SST, tap in a new rear engine oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09608-36010  
09950-70010  (09951-07100)

NOTICE:

Do not tap in the rear engine oil seal at an angle.



Hide 13450 2.INSTALL FLYWHEEL WITH DAMPER ASSEMBLY

a.

Install the crankshaft position sensor plate to the crankshaft.


b.

Temporarily install the flywheel with damper assembly with 8 new bolts.


c.
A315454E02
1.927,1.396 2.5,1.667 2.5,1.667 2.667,1.667 true 2.708,1.583 3.167,1.781 0.458,0.198 10 false SST

Using SST, secure the flywheel with damper assembly.

SST:

PZ4TB-04939-38



d.
A318536E01
1.99,1.198 2.5,0.833 2.5,0.833 2.75,0.833 true 2.792,0.75 3.25,0.948 0.458,0.198 10 false SST

Using SST, tighten the 8 bolts.

SST:

PZ4TB-04910-18


Torque:
: 120 N*m (1224 kgf*cm, 89 ft.*lbf)


e.

Remove SST.


Hide 31250 3.INSTALL CLUTCH DISC ASSEMBLY

Hide 31210 4.INSTALL CLUTCH COVER ASSEMBLY

Hide 31210 5.INSPECT AND ADJUST CLUTCH COVER ASSEMBLY