1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
11212
4.REMOVE NO. 2 CYLINDER HEAD COVER
17705
5.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
6.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.
7.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
74404A
8.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28800
9.REMOVE BATTERY
74431
10.REMOVE BATTERY TRAY
16057
11.DISCONNECT RADIATOR HOSE SUB-ASSEMBLY
74411B
12.REMOVE FRONT BATTERY BRACKET
74414B
13.REMOVE BATTERY BRACKET REINFORCEMENT
89413P
14.REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)
Disconnect the connector.
Remove the bolt and transmission revolution sensor (NIN) from the continuously variable transaxle assembly.
Remove the O-ring from the transmission revolution sensor (NIN).
89413M
15.REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)
Disconnect the connector.
Remove the bolt and transmission revolution sensor (NOUT) from the continuously variable transaxle assembly.
Remove the O-ring from the transmission revolution sensor (NOUT).
89413N
16.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)
Disconnect the connector.
Remove the bolt and transmission revolution sensor (NT) from the continuously variable transaxle assembly.
Remove the O-ring from the transmission revolution sensor (NT).