Home › Engine / Hybrid System › 2WW STARTING › GLOW PLUG CONTROLLER › from 2015.10
RM3090E _51 Engine / Hybrid System _044379 2WW STARTING _0219539 GLOW PLUG CONTROLLER A

2WW STARTING  GLOW PLUG CONTROLLER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12612A 3.REMOVE NO. 1 ENGINE COVER

Hide 28550 4.REMOVE GLOW PLUG CONTROLLER ASSEMBLY

a.
A316910

Disconnect the 2 glow plug controller assembly connectors.


b.

Using a T25 "TORX" socket wrench, remove the bolt and glow plug controller assembly.