Home › Engine / Hybrid System › 2WW STARTING › GLOW PLUG CONTROLLER › from 2015.10
RM3090E _51 Engine / Hybrid System _044379 2WW STARTING _0219539 GLOW PLUG CONTROLLER A

2WW STARTING  GLOW PLUG CONTROLLER  INSTALLATION  


PROCEDURE

Hide 28550 1.INSTALL GLOW PLUG CONTROLLER ASSEMBLY

a.
A349857C01
0,0 0,0 false
*1 Guide
V113147

Install in this Direction


Using a T25 "TORX" socket wrench, install the glow plug controller assembly with the bolt as shown in the illustration.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Connect the 2 glow plug controller assembly connectors.


Hide 3.CONNECT CABLE TO BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION