Home › Engine / Hybrid System › 2WW STARTING › GLOW PLUG › from 2015.10
RM3090E _51 Engine / Hybrid System _044379 2WW STARTING _0219540 GLOW PLUG A

2WW STARTING  GLOW PLUG  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 12612A 3.REMOVE NO. 1 ENGINE COVER

Hide 82121 4.DISCONNECT ENGINE WIRE

a.
A316913

Using a T25 "TORX" socket wrench, remove the screw and disconnect the engine wire so that the glow plug assemblies can be removed in a later step.


Hide 19850 5.REMOVE GLOW PLUG ASSEMBLY

a.

Disconnect the 4 glow plug assembly connectors.


b.
A316914N01
0.677,0.75 0.823,0.469 0.823,0.469 1,0.469 true 1.042,0.375 1.396,0.583 0.354,0.208 10 true SST

Using SST, remove the 4 glow plug assemblies.

SST:

PZ4TB-04910-68