Home › Engine / Hybrid System › 2WW STARTING › GLOW PLUG › from 2015.10
RM3090E _51 Engine / Hybrid System _044379 2WW STARTING _0219540 GLOW PLUG G

2WW STARTING  GLOW PLUG  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 82121 1.DISCONNECT ENGINE WIRE

Hide 19850 2.INSPECT GLOW PLUG ASSEMBLY

a.

Disconnect the 4 glow plug assembly connectors.


b.
A316912

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Glow plug assembly terminal - Glow plug assembly body 20°C (68°F) 0.1 to 0.9 Ω


If the result is not as specified, replace the glow plug assembly.

NOTICE:
·

Be careful not to damage the glow plug assembly as this may cause an open circuit or shorten the life of the glow plug assemblies.

·

Prevent oil and fuel from spraying onto the glow plugs when cleaning.

·

Clean any oil on the terminal and bakelite washer with a dry cloth.




c.

Connect the 4 glow plug assembly connectors.


Hide 82121 3.CONNECT ENGINE WIRE